Pressure Washing Decks
|
A beautiful wooden deck, properly maintained, can add greatly to the aesthetic and resale values of a home.
Just look around, decks are almost everywhere. Not just houses but both municipal and commercial facilities use wooden decks and walkways extensively. Because of this pressure washing decks can be a great profit center for your business or even the whole business.
The great news is that decks need maintenance. As beautiful as a wooden deck can be it can be a real eyesore if not properly maintained.
Why Decks Need Maintenance
When a wood deck absorbs water the natural resins and color can be washed out over time.
The combination of wood and water creates a food source for mildew, fungus and mold promoting their growth. Wood and water combined with dirt and even air pollutiom will also contribute to the proliferation of mildew, fungus and molds. One thing to remember is that a wet deck with a thick coating of mildrew is very slick and slippery. This creates one heck of a "slip and fall" liability problem. Keep this in mind when speaking to the decision makers of commercial and municipal facilities.
Learning Curve
There is a learning curve involved when getting proficient enough to clean/seal/restore wood decks for the public. It is best to learn on your own deck or on the decks of close friends and relatives. When learning make sure to do more than one. Different decks can present different challenges.
Inspect
When organizing your project or preparing your bid make some simple observations.
Has the deck ever been sealed? Is there old sealer that needs to be stripped and reapplied?
Do I have all the chemicals, tools and equipment required for this project?
( we will include a sample list at the end of this article)
Is there any damaged or rotted wood that needs to be replaced?
( Now is a good time to measure.)
Are the any missing or loose bolts, nails or screws?
Are there any adjacent bushes or plants that need to be protected?
Are there any electrical appliances, outlets, light fixtures or telephone jacks?
Note: these will have to be sealed water tight. Remember water and electricity is a dangerous combination. Decks in upscale neighborhoods will probably contain most of these challenges. Make sure the circuit breakers will be accessible to you prior to starting.
Beginning
Ok you've cleared everything from the deck and placed it far enough to be out of harms way. You've locked out the circuit breakers that provide electrical service to the deck area. Outlets, fixtures and jacks have been sealed water tight.
Close proximity plants and bushes have been protected with a clear plastic tarp.
Loose bolts. nails and screws have been tightened or replaced.with galvanized fasteners.
Rotted or damaged wood has been replaced.
Only now are you really ready to begin.
Clear the Deck of Dirt and Debris
With a stiff bristle broom or a leaf blower clear all loose dirt and debris from the surface of the deck..
What Chemicals to Use
Sodium Hydroxide ( a high caustic chemical) is very popular with professional deck cleaners. Because this chemical does most of the work very low pressures of 500-1200 PSI can be used which helps avoid the condition known as "furring".
Safety note: Always wear headgear with face shields and cartridge type respirators when working with high caustic or acidic chemicals. This is not a suggestion it's a must.
While Sodium Hydroxide is a very effective chemical it will darken or may even blacken the deck. Because of this the PH will have to be nuetralized with a mild acidic solution. Acids used are Citrus,Oxalic or Phosphoric.
These acid solutions will act as brighteners. Neutralizing the PH of a high caustic cleaner will restore a deck very close to it's original color.
Add approx. 5oz. acid to each gallon of water.
Citrus Acid- Used on hardwoods.
Oxalic Acid- Primarily used on redwoods.
Phosphoric Acid- Used when an unfinished deck has turned "gray".
I'm very hesitant to suggest a pressure level when it comes to cleaning decks because it's just so subjective. One deck will have harder wood than another and
other decks will have softer and harder areas on the same deck. In this respect only experience can really guide you. As a general rule of thumb use the least amount of pressure that will get the job done.
Test pressure on an inconspicuous area of the deck. The underside works well for this
Excessive Pressure.
Excessive pressure will cause a deck to "furr".This is the appearance of small hairlike fibers protruding from the wood.. Your customers will not like the way this looks and light sanding will be required to correct this condition.
Ready, Set, Go!
Soak the area to be cleaned thoroughly. This serves several purposes but most importantly, the deck must remain damp throughout the entire cleaning process.
Apply cleaning chemical with the applicator of your choice.When just starting out a pump up type sprayer will work nicely. Allow your chemical to dwell for 15-20 minutes. Do not allow to dry. If necessary spray more water or reapply chemical.
If you've sufficiently dampened the deck and haven't dawdled this shouldn't be a big problem.
Clean. Remember when cleaning use low pressure. Never clean against the grain or accross the grain. Feather each pass. The pressure used should be enough to remove dead wood but not enough to cause "furring" Experience will be your best teacher.
Rinse deck thoroughly removing all chemical. Apply nuetralizer/brightener solution, wait 10-15 minutes and rinse well again.
If you are going to seal wait 24 hours if not 48. If you chose your day well rain won't become a problem.
"Furring" Happens.
Sometimes "furring will become apparent even at low pressures. These short hair like fibers are the result of a "tearing" action on the wood. These will probably be gone in 2-3 weeks but your customer will want them gone sooner than later. Give them a light sanding with a bronze metal scrubbing pad. Use bronze, steel wool can leave rust stains.
What not to leave behind
Here is a general list of things to bring to your job site. Some of this may not apply to you. The point is to always work with a job list to avoid the embarrasment or expense of missing that tool you need right now.
Pressure Washer- Cold water gas machine 5.5-11HP commercial grade unit.
(Hot Washers are also used but at very low temperatures not exceeding 110F)
Hoses- Sufficient lengths of both pressure hose and supply hose.
Brooms/Blower- A stiff bristled push broom (not metal) and/or a gas powered leaf blower.
Chemical applicator - Pump-up type sprayer or Flo-Jet type sprayer
Mixing Buckets - 2or3 5 gallon plastic mixing buckets.
Mixers- Drill type chemical mixer.
Respirator- Cartridge type with spares
(When working with high caustics and acids)
Face and Eye Protection- Some type of helmet with face shield.
Cordless Drill- With phillips screwbit and chuck large enough to accomodate chemical mixer.
Hammer- If nails are required.
Deck Screws, Nails and Bolts- As required, use galvanized only.
Duct tape, Clear plastic sheeting,Cardboard- To protect areas
Extension Cords- Must be adequate length and gauge. 12 gauge minimum.
Electric Rotary Sander- With 60 and 80 grit sandpaper
Knee Pads - You didn't think you'd always be standing when sanding did you?
Remember practice makes perfect get out there and start learning.
About the Author
Randall Madon is the founder and president of ATT Pressure Supply along with a new educational resource site:
The-Power-Washer-Advisor.com - Learn More.
|
|
|
Orchid Myths -the Truth
Here are some of the popular orchid myths#1 Orchids are CarnivorousThey are not, in fact, they pollinate by luring insects to them but they do not eat the insects. This helps the orchid gardeningOrchid My...(related: Landscaping)
Caring For Tropical And Exotic Flowers
Tropical flowers make an exciting change from the more traditional floral gifts such as roses and gerberas, assuming that they're available in your area. Their stark and colorful beauty makes them an impressive gift for special occasions like Mother's Day, Valentine's Day, birthdays and anniversaries.If you're lucky enough to grow tropical flowers such as heliconias or gingers in your garden, here are some tips to help them thrive and to extend their shelf life as cut flowers.1. Water your plants well a...(related: Landscaping)
Garden Room Boundaries
The areas of your landscape can be divided into several sections and areas, which are also known as garden rooms. Garden rooms are spaces where you plant, grow, and display different ideas in gardening in various creative methods. One garden room could be a rose garden, while another could include the use of a water garden, while still another garden room in your landscape could include the use of just purple flowers. Garden rooms are your creation, and only limited to your imagination.To create the rooms in your landscape where you can be both differen...(related: Landscaping)
Growing Orchids As House Plants
One of the long standing myths that I still hear is that orchid house plants are difficult and finicky to grow. Well, plain and simple, the answer is No. In fact, orchids as house plants are easy to grow and will continue to bloom for years. Some orchid plants have been around for centuries.WateringOrchid house plants and orchid plants in general will need watering periodically, usually you can water once a week. Remember, most orchids are air plants and this means you will see their roots. Their root system is very efficie...(related: Landscaping)
Planning Permission Tips Uk - Landscaping Schemes - Do They Add Value-is It The Chicken Or The Egg?
Have you noticed how everything looks great at the moment - in the garden and parks I mean. Everything seems in bloom, full of colour and life. This is a great time of year for biking as well but that's another story.Can you remember last years new development along your street that now seems a little more integrated into the landscape or street scene?Planting....Its all about planting and using plants and trees to soften new buildings into their environment. In the seventies and eighties this was a very low priority for residential development schemes & even today, poorly landscaped developments look just that unless their new owners have had a sympathetic hand.Landscaping normally falls into two distinct categories - hard ...(related: Landscaping)
Furniture Benches Are Perfect For Every Outdoor Space
The task of selecting outdoor furniture for your natural spaces can seem daunting at times. There are just so many options to choose from that many people get confused browsing through the large collections that can be found in catalogues, s...(related: Landscaping)
Canopy Swings - Escape The Weather With One
Do you love to sit outdoors and swing for hours but have to cut your relaxing excursions short due to the intense sun or brief summ...(related: Landscaping)
Metal Garden Furniture
Since Victorian times metal garden furniture has become a popular way to decorate gardens. In fact, since this furniture can easily last for many years with the proper maintenance, some people are still using pieces in their gardens that were made in the Victorian era. Metal garden furniture adds both a classic style and durability, which demand that it should be considered as the preferred choice of garden furniture...(related: Landscaping)
Durable Wooden Swing - Decorate Your Outdoors With One
There is nothing better to do on a hot, lazy afternoon than to lounge in your favorite outdoor swing while reading, napping or just watching the world pass by. And when evening approaches and the breeze gets cooler, an outdoor swing is also the perfect place to sit and unwind after a hard day while you watch the fireflies light up the ever darkening sky.The truth is that an outdoor wooden swing offers more than just a place to sit and relax. Seating areas created with wooden swings become outdoor rooms and extensions of the ...(related: Landscaping)
Using Push Reel Mowers
If you're not familiar with push reel mowers or if you haven't used one since "back in the day", there are a few points you should be aware of before using a push reel mower:
- Don't expect to cut tall weeds or dandelions. You notice how your gas-powered mowers get a little "overwhelmed" when cutting weeds or very tall grass? Those issues are a bit worse with reel mowers because they become harder to push and they are limited in the height of what they can cut. When cutting with a power mower, you can tilt the mower in order to access hard-to-cut areas. That's not so with a reel mower, you can only cut grass below the cutting height bar.
- Don't cut wet grass. The wheels need traction in order to move the blades and if the wheels are slipping, especially if you're cutting taller grass or weeds, the ...(related: Landscaping)
How To Grow Sweet Corn
Purchased corn, whether on the cob or in a can can't compare for taste! Sweet corn is easy to grow in the flower and fruit gardening guides home garden with just a little know how and a few corn facts.Corn needs warm soil temperatures (50° - 65° Fahrenheit) to germinate.Warm temperatures cause sugars in corn to turn into starches and results in loss of sweetnes...(related: Landscaping)
Canopy Swings - Escape The Weather With One
Do you love to sit outdoors and swing for hours but have to cut your relaxing excursions short due to the intense sun or brief summ...(related: Landscaping)
links - site-map - Copyright © 2006 datorsam.com | Contact Webmaster | All Rights Reserved. | Landscaping